Conference Proceedings

Fourth International Conference On Advances in Civil, Structural and Mechanical Engineering -ACSM 2016

Design of Heat Pipe Heat Exchanger with Plate Fins by two Methods LMTD and ε-NTU

Author(s) : ALI KARGAR , MAJID LOTFI

Abstract

In this study, the effective factors on the heat transfer and pressure drop in heat pipe heat exchanger design based on the LMTD and effectiveness-NTU has been investigated. Increasing fuel cost and energy conservation, fuel consumption and also, pollution air are the most important consideration to be taken in new heat exchanger design, and modern compact heat exchangers. This paper describes a theoretical method to the design and performance of heat pipe heat Exchanger. Design of heat pipe heat exchanger for identifying of the principal parameters, which can optimize the performance of heat exchanger. Heat pipe heat exchanger efficiency with copper pipes is 10% higher than steel but steel pipe for strength and its ability to heat recovery of hot gases is preferred. Increasing the number of rows of tubes will increase efficiency. The largest diameter pipes and increasing the number of fins improved efficiency. Pressure drop of the heat pipe heat exchanger placed as heat recovery unit in hot gas duct of boilers and furnace depends on velocity and it is very important.

Conference Title : Fourth International Conference On Advances in Civil, Structural and Mechanical Engineering -ACSM 2016
Conference Date(s) : 07-08 May 2016
Place : Hotel Lebua at State Tower, Bangkok, Thailand
No fo Author(s) : 2
DOI : 10.15224/978-1-63248-096-5-13
Page(s) : 24 - 27
Electronic ISBN : 978-1-63248-096-5
Views : 588   |   Download(s) : 146